Power Supply 24Vdc 2.5Amp 60W IP67

<p><strong>TECHNICAL SPECIFICATIONS:</strong></p> <ul><li>Dimmable LED Driver</li> <li>Designed for dimming LED strips.</li> <li>IP67 waterproof plastic enclosure.</li> <li>Input range: 90-305V AC 47-63Hz</li> <li>Output voltage: 24V DC.</li> <li>Output current: 2.5A.</li> <li>Output current range: 0-2.5A depending on load demand.</li> <li>Power: 60W.</li> <li>Typical efficiency: 89%.</li> <li>0% to 100% output current dimming with a 0-10V / 1-10V regulator, 10V PWM signal with a frequency of 100Hz to 3KHz or resistance from 0 to 100K Ohms.</li> <li>With regulation, we can turn off the output, but we need a 0-10V regulator.</li> <li>1-10V regulators, since they don't reach 0V, do not turn off the output.</li> <li>Input class II without grounding.</li> <li>Power factor correction >0.95 at 230Vac at full load.</li> <li>No-load consumption <0.5W.</li> <li>Operating case temperature range Tc from -40ºC to 85ºC.</li> <li>Dimensions (Length x Width x Height): 150 x 53 x 35mm.</li> <li>5-year warranty.</li> </ul><p>The series <strong>PWM-60</strong> are LED drivers designed to work directly with LED strips. <br />They must be powered by a constant voltage.<br />With a plastic housing, they are intended for interior, decorative, or architectural lighting applications.<br />They can be regulated with active or passive 0-10V or 1-10V dimmers, a 10V PWM signal from 100Hz to 3KHz, or by a 0-100Kohm resistor. <br /><strong>Does not work with phase-cut Triac dimmers. (Do not confuse this with phase-cut TRIAC dimmers. This driver cannot be regulated with a Triac.) <br />With active potentiometers that can output 0V, the output can be turned off without a switch. <br />With 1-10V dimmers, only 10% dimming is possible without turning off the output. With its pulsed output, it can regulate any LED strip, no matter how small, as long as the driver's maximum load is not exceeded. Because the driver and regulator are integrated into the same unit, any compatibility issues are eliminated, reducing both cost and size. Its high-frequency design prevents any audible noise at any dimming level. It is compatible with any 0-10V or 1-10V regulator on the market, both active and passive. <br />Some compatible models tested are:</p> <ul><li>MEAN WELL: DAP-04S01 (compatible with any normally open push button).</li> <li>SIMON: 75317</li> <li>BJC: 5TC8 425</li> <li>LEGRAND: 0784 04</li> <li>ABB-NIESSEN: N2260.9</li> <li>SIEMENS: 5TC8424</li> <li>EFAPEL: Model 21210</li> <li>LED BOX: Model LD1160188</li> <li>OSRAM: DIM model</li> <li>MCU JUNG: Model 240-10</li> </ul><p>We can put about 20 sources for each regulator. The maximum distance between the regulator and the driver is 100 meters.